Raspberry Pi, ESP32, PCB and More
-
Pico-Ice board combines Raspberry Pi RP2040 MCU with Lattice ICE40 UltraPlus 5K FPGA
tinyVision.ai Pico-Ice is a development board with a Raspberry Pi RP2040 MCU and a Lattice ICE40 UltraPlus 5K FPGA connected through an 8-bit bus. The Arm Cortex-M0+ microcontroller provides the clock for the FPGA and can program the FPGA directly or the dedicated FPGA flash using a drag-drop of a UF2 file.
-
Variscite teases i.MX 91 based System-on-Module with GbE support
This week, Variscite revealed at Computer that they will soon release a low-cost System-on-Module based on the latest NXP i.MX 91 processor optimized for Linux-based applications.
-
Hackaday Prize 2023: LASK4 Watches Those Finger Wiggles
What do you get when you combine an ESP32-S2, a machine-learning model, some Hall effect sensors, and a grip exercise toy? [Turfptax] did just that and created LASK4. The four springs push down pistons with tiny magnets on them. Hall effect sensors determine the piston’s position, and since the springs are linear, the ESP32 can also estimate the force being applied on a given finger. This data is then streamed to a nearby computer over TCP. A small OLED screen shows the status, and a tidy 3D printed case creates a comfortable package.
-
Hackaday Podcast 221: The Future Of The Raspberry Pi, Sniffing A Toothbrush, Your Tactical Tool Threshold
Editors Elliot Williams and Tom Nardi are back in the (virtual) podcast studio to talk the latest phase of the 2023 Hackaday Prize, the past, present, and future of single-board computers, and a modern reincarnation of the Blackberry designed by hardware hackers. They’ll also cover the current state of toothbrush NFC hacking, the possibilities of electric farm equipment, and a privately funded satellite designed to sniff out methane. Stick around till the end to find out if there really is such a thing as having too many tools.
-
What Makes Wedge Coils Better Than Round For PCB Motors?
PCB motors are useful things. With coils printed right on the board, you don’t need to worry about fussy winding jobs, and it’s possible to make very compact, self contained motors. [atomic14] has been doing some work in this area, and decided to explore why wedge coils perform better than round coils in PCB motor designs.
-
SMA Connector Footprint Design For Open Source RF Projects
When you first start out in the PCB layout game and know just enough to be dangerous, you simply plop down a connector, run a trace or two, and call it a hack. As you learn more about the finer points of inconveniencing electrons, dipping toes into the waters of higher performance, little details like via size, count, ground plane cutouts, and all that jazz start to matter, and it’s very easy to get yourself in quite a pickle trying to decide what is needed to just exceed the specifications (or worse, how to make it ‘the best.’) Connector terminations are one of those things that get overlooked until the MHz become GHz. Luckily for us, [Rob Ruark] is on hand to give us a leg-up on how to get decent performance from edge-launch SMA connections for RF applications. These principles should also hold up for high-speed digital connections, so it’s not just an analog game.