Linux Devices: Librem, Raspberry Pi, Arduino, and More




-
Weekly #LinuxPhone Update (17/2022): Plasma Mobile Gear 22.04, Nemo Mobile 0.9 and Phosh gesture support is inching closer!
It's saturday, Linux App Summit is taking place. There's some bad news regarding open modem firmware and I am writing this in a train slowly but surely taking me to the sea for some time off.
-
Self Hosted forum with phpBB and Raspberry PI
King of self-hosted forum platforms, phpBB has a strong story and is spreadly used. As its name suggests, it is based on PHP and is so light that you can run your self-hosted forum with phpBB on Raspberry PI
In this tutorial, I’m going to show you how to install phpBB and configure your very first topic on a cheap Raspberry PI Zero W.
phpBB is an open-source (Licensed under the GPLv2) forum software, built with a bulletin board logic, that can link a group of people or can power an entire website. Its features can be extended using extensions that can be installed and configured with few clicks.
PhpBB includes a customizable registration process for your users, allowing administrators to manage permissions up to a fine level. -
Improving the Stability and Reliability with a Modular Modem in the Librem 5 – Purism
Usually we can fully rely on our phones to be reachable at any time—given cellular reception of course—and we take that for granted.
You surely know situations in your life where that becomes especially critical. Be it when you’re expecting an important call or when you need to be able to receive “emergency” calls in general. The Librem 5 phone is the primary device for the majority of our team, therefore the stability and reliability for us is equally as important for us as our customers.
The Librem 5 phone is a pretty exceptional device. It’s a general- purpose computer running the same software that laptops run. Plug in a cellular modem into a laptop and you have roughly the same thing in just a different form factor.
One of the hardest things these days is to get a removable cellular modem card that does audio calls in the first place. It’s a tough market full of proprietary hardware and software where licensing requirements inhibit modems from doing audio calling. For the Librem 5 phone we found one but we can really consider ourselves fortunate as it was and will continue to be a supply chain challenge.
-
DIY SBC cases and SBC Case Builder tool based on OpenSCAD - CNX Software
Since you can’t always rely on single board computer (SBC) vendors to provide a case to match your needs, some went the DIY route. Willy Tarreau designed some laser-cut enclosures with Inkscape for various SBCs, while hominoids went a step further by developing the “SBC Case Builder” tool to automatically generate various types of 3D printable enclosures using OpenSCAD.
-
Firmware updates, part 1: Bootloader
This is the first post in a series about doing device firmware updates (DFU) over the air (OTA) and continuous delivery of firmware for embedded devices. We'll explore the different parts of a complete end-to-end system with this capability.
This post will be about a fundamental component in such a system: the bootloader.
-
Shedding light on power plant control networks
Like all critical infrastructure sectors, the energy sector has become reliant on automation techniques to monitor and control its networks. However, not much is publicly known about these techniques or the networks that tend to use proprietary protocols and operate in closed settings.
To address this knowledge gap, we at the Brandenburg University of Technology, recently conducted a project to study the design of industrial control networks that run power plants. Below are some of our key takeaways that we presented recently at PAM 2022.
-
How effective is HTTPS/TLS usage in the consumer IoT ecosystem?
Unfortunately, little is known about the degree of effectiveness with which IoT devices use TLS. What’s more worrisome is that TLS usage in other non-browser software has been found to be particularly problematic, with some experts calling it “the most dangerous code in the world”.
To fill this knowledge gap, we at Northeastern University and IMDEA Networks studied ~17M TLS IoT device connections. The following post offers a brief snapshot of what we discovered and presented at IMC 2021.
-
Arduino And Git: Two Views
You can’t do much development without running into Git, the version control management system. Part of that is because so much code lives on GitHub which uses Git, although you don’t need to know anything about that if all you want to do is download code. [Dr. Torq] has a good primer on using Git with the Arduino IDE, if you need to get your toes wet.
-

- Login or register to post comments
Printer-friendly version- 2813 reads
PDF version
More in Tux Machines
- Highlights
- Front Page
- Latest Headlines
- Archive
- Recent comments
- All-Time Popular Stories
- Hot Topics
- New Members
digiKam 7.7.0 is released
After three months of active maintenance and another bug triage, the digiKam team is proud to present version 7.7.0 of its open source digital photo manager. See below the list of most important features coming with this release.
|
Dilution and Misuse of the "Linux" Brand
|
Samsung, Red Hat to Work on Linux Drivers for Future Tech
The metaverse is expected to uproot system design as we know it, and Samsung is one of many hardware vendors re-imagining data center infrastructure in preparation for a parallel 3D world.
Samsung is working on new memory technologies that provide faster bandwidth inside hardware for data to travel between CPUs, storage and other computing resources. The company also announced it was partnering with Red Hat to ensure these technologies have Linux compatibility.
|
today's howtos
|








.svg_.png)
Content (where original) is available under CC-BY-SA, copyrighted by original author/s.

Recent comments
1 year 11 weeks ago
1 year 11 weeks ago
1 year 11 weeks ago
1 year 11 weeks ago
1 year 11 weeks ago
1 year 11 weeks ago
1 year 11 weeks ago
1 year 11 weeks ago
1 year 11 weeks ago
1 year 11 weeks ago